|Rated Voltage:||220V/110V||Application:||Vacuum Tube Non Pressurized Solar System|
|Temperature Range:||0～99℃||Electromagnetic Valve:||DC 12V AC 220V|
|Type:||Intelligent Solar Water Heater Controller||Using:||Fill Water|
solar hot water controller,
solar water heating controller
Intelligent Solar Collector Controller SR501 Non Pressure Solar Water Heater
Suitable for integrated un-pressurized solar system
Main Technical data:
1 Dimension: 210 mm x 145mm x 40mm
2 Self power consumption: <3W
3 Measuring accuracy of temperature: ±2℃
4 Temperature range of measurement: 0～99℃
5 Maximum power of controlled pump: ≤600W
6 Power of accompanied electrical heating wire: ≤800W
7 Power of auxiliary electrical booster ≤2000W ( standard collocation),
≤3000W (not standard selection available )
8 Electromagnetic valve parameter: DC 12V AC 220V
pressurized valve and un-pressurized valve are available for selection
※ operation pressure of pressurized valve: 0.02Mpa ~ 0.8Mpa
suitable for providing water directly
※operation pressure of un-pressurized valve: 0.0Mpa
connected with water tank or low pressure water providing
1, Time display
2, Water temperature display
3, Water level display
4, Auto mode
5, Water level pre-setup
6, Manual water loading
7, Temperature controlled water loading
8, Timing water loading
9, Water loading when tank is lack of water
10,Compulsive water loading
11,Increasing Water pressure during water is loaded.
14,Hot water circulation
15,Hot water pipe insulation
16,Low pressure protection
17,Collector tube protection
18,Memory protection when power is failure
System Working Pricinple:
Description: this system is water and collector integrated solar water
system, it is easy for mounting, and efficiency is high.
1. Inner tank material: SUS304-2B food grade stainless steel 0.31mm
2. Outer tank material: stainless steel sheet 201, thickness 0.31mm,
3. Bracket:1.2mm SS 202 stainless steel sheet
4. Vacuum tube: 58mm diameter, 1800mm length,coated by AL-N-AL
5. Insulation layer: 50-65mm polyurethane foam
6. Hail resistance:25mm 7.Heat preservation:72hours
This type use all-glasses evacuated tubes as the solar collector for absorbing sun energy and transferring
it into heat energy.
As the different densities of hot water and cold water, the hot water flows automatically upwards while the cold water flows down.
The water flowing cycle is created in the tube. And the water in the storage tank is heated from this natural circulation.
The hot water pressure of this non-pressure system is from the gravity, so it should be installed on the roof or at least 3-4 meters higher than hot water tap.
Or you can install a booster pump to get stronger outlet hot water.
|Inner Tank Material||Stainless Steel||Stainless Steel||Stainless Steel|
|Inner Tank Diameter||360mm||360mm||360mm|
|Outer Tank Material||Colored Steel||Colored Steel||Colored Steel|
|Outer Tank Diameter||460mm||460mm||460mm|
Contact Person: Passionsolar